The terminating character (also referred to as the suffix, footer or trailer) is that character, if any that the application software is expecting after the bar code data. The trailing character is usually a horizontal tab or a carriage return. Below are bar codes to set the trailing character to the 4 most popular settings. In some cases, more than one bar code needs to be scanned in order to set the terminating character.
If the terminating character(s) required by your software are not in this manual, you will need to get them from the factory.
Carriage Return (CR)
To set the terminating character to carriage return, scan the foLLowing three bar codes in order:
Trailer=
Carriage Return (CR)
End
Carriage Return/Line Feed (CR/LF)
To set the terminating character to carriage return, scan just the following bar code:
Trailer= Carriage Return/Line Feed (CR/LF) (default)
Horizontal Tab (HT)
To set the terminating character to horizontaL tab, scan the foLLowing three bar codes in order:
Trailer=
Horizontal Tab (HT)
End
None
To set the terminating character to none, scan the foLLowing two bar codes in order:
Trailer=
End