Features of the MW-400 Bar Code Reader
Supported Bar Codes
LED Feedback
MW-400 Installation &. Use
General Scanning Tips
Best Orientation
Configuration
Supported Symbologies
Bar Code Menu Programming
Syntax Errors
Enabling, Disabling &. Formatting Bar Code Symbologies
Code 39
Interleaved 2 of 55
UPC/EAN/]AN
Codabar
Code 128
Code 11
MSI Code
Code 93
Communication Settings
Baud Rate
Parity
Stop Bits
Enable Xon/Xoff (DCl/DC3) Character Handshake
Set Terminating Character (Trailer)
Appendix
A Troubleshooting
The information contained in this document is subject to change without notice. TPS Electronics makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchamability and fitness for a particular purpose. TPS Electronics shall not be liable for errors contained herein or for incidental or consequential damages in connection \vi.th the furnishing, performance, or use of this material. Some material is Copyright 1993, Hewlett~Packard Company and is reprinted by permission. This document contains proprietary informalion that is protected by copyright. All rights are reserved. The information contained in this document is subject to change without notice.
WARRANTY
The MW-400 Bar Code Reader is warranteed for a period of two years after purchase covering defects in material and \vorkmanship. TPS Electronics will repair or, at its option, replace products that prove to be defective in material or workmanship that fail to function properly under proper use during the warranty period.
FCC CERTIFICATION AND INFORMATION TO USER
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance wi.th the instructions, may cause interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation, If this equipment does cause interference to radio or tele\ision reception, which can be detennined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the fonowing measures: - Reorient the computing device. - Increase the separation between the equipment and the computing device. -Consult the dealer or an experienced radio/TV technician for help.
FCC IDENTIFICATION: FCC lD B94KDRZ FCC DISCLAIMER
Ihis IPS Electronics product has received FCC certification for its standard configuration only. Any customer purchasing the product with stripped and tinned leads or a connector without adequate shielding, or who purchases the standard MW-400 and removes or otherwise modifies the connector or housing has the responsibility to comply with FCC regulations. Moreover, if the MW-400 reader is purchased under the above circumstances, the product becomes defined as a subassembly and the FCC Identification number no longer applies. IPS Electronics assumes no responsibility or liability for users of the IPS Electronics MW400 readers without connectors that fail to comply with FCC regulations. Other changes or modifications not expressly approved by TPS Electronics could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: ( 1) This dnice may not cause harmful interference, and (2) this device must accept any interference received, induding interference that may cause undesired operation.